Sage 100

v4.5 VI date error during a test import and now it still says it is running in import maintenance. I thought there used to be a button to stop it(reset button greyed out). Don't see it. How do I stop it?

If memory serves me right, you need to click on the Job info button and at that point you will either be prompted to stop the job or you will see a stop button.

Is there a Cycle button in 4.5? I think you can stop it there too.

Job info button nothing just says running and cycle button grey out. Found a log file and renamed it thinking that might help, but no

Supervisor rights checked for VI?

have that set. I was able to create a new job and copy from one running so for now I have it working.

@KellySappington if it's a business framework module that you are importing into, all you have to do is accept the job in VI maintenance and that stops it and flips the flag back to not running,

After trying new import routine, it got same error message. Once I went back into it and went to Job info the Unlock button showed up. Actually integrated with JobOps importing into SO

here's error, not finding anything error 43 in program VIWASN at line 7720 (format mask invalid. Weird because this routine has been used for quite a while.

Did you try this? Select File, Run in Sage 100 ERP Enter SVCMPL and click OK button Select ""Select All"" and click ""Proceed"" Open the import job in Import Job Maintenance and the dictionaries will automatically recompile