My general rule is the same as Javier, after taking a system backup (MAS90 / MAS_System).
After running the server install (repair / adding a module) or installing a product update, I re-install all enhancements that show in the installed modules listing, then run the data conversions (company data / enhancements) and custom office update panels utility. That is good to know about ScanForce not needing a re-install, but it is an exception (rather than the rule).
Some enhancements require updated versions for a PU (where you want to check with the developer...), and some updated enhancement updates require special instructions.
------------------------------
Kevin Moyes
Technical Systems Analyst
Munjal White Consulting Co.
Toronto ON
------------------------------
Original Message:
Sent: 11-25-2024 11:46
From: Sue Wolf
Subject: ScanForce WMS Premium v2023 with PU4 Update
I checked with ScanForce Support on this. They said that you don't need to install "ScanForce WMS Premium v2023 w Labeling" after installing a Sage Product Update, but if you have Multi-Bin installed, you need to install the latest Multi-Bin build after installing a product update.
------------------------------
Sue Wolf
Senior Solution Architect
RKL eSolutions, LLC, Appleton, WI
m: (484) 874-2225
e: smwolf@rklesolutions.com
------------------------------
Original Message:
Sent: 11-22-2024 23:54
From: Javier Guzman
Subject: ScanForce WMS Premium v2023 with PU4 Update
Hi Sue,
I don't have much experience with Premium but I assume it is the same as Standard/Advanced when it comes to installs. You do want to reinstall all mods after installing a product update or a full upgrade. You might not need to get a new version of the mods when doing a Product Update but I would definitely check with the developer to see if you need to install an update of their software after installing the PU.
Javier
------------------------------
Javier Guzman
Consultant
ProSolutions