Sage 100

Running paperless PR stubs on the server (to see if can speed process), getting this error after about 10 minutes during the process, could not find anything on it. Any clues, already reran wksetup.

I think this is related to the crpe32.dll being incorrect or damaged or not in the correct directory? What version is this? A couple of KB articles: https://support.na.sage.com/selfservice/viewdocument.do?noCount=true&externalId=27138&sliceId=1&cmd=displayKC&dialogID=118088&docType=kc&isLoadPublishedVer=&stateId=118090&docTypeID=DT_Article&ViewedDocsListHelper=com.kanisa.apps.common.BaseViewedDocsListHelperImpl https://support.na.sage.com/selfservice/viewdocument.do?noCount=true&externalId=52371&sliceId=1&cmd=displayKC&dialogID=118130&docType=kc&isLoadPublishedVer=&stateId=118133&docTypeID=DT_Article&ViewedDocsListHelper=com.kanisa.apps.common.BaseViewedDocsListHelperImpl

have you actually run workstation setup on the server? I've run into weirdness like this before when we have installed Sage100 on the server but not ever actually run the wksetup

Oh, the infamous swocx error on a legacy module. Sounds like crepe32 issues. I agree with @ThereseLogeais above.

I would try Therese's suggestion first. If that doesn't work, It could be print driver related. From report designer try File, Page Setup, check the ""No Printer"" box.

same error different line - older version Subject: ""Crystal Error: Exception occurred (err-ret=22/0) occurred on line 1640 in program SWCOCX"" when printing Crystal forms or reports. Possible Resolution: Note: Crystal Reports must be installed to perform these procedures. Sage Software Customer Support is not responsible for assisting with the use of non-Sage Software products. For assistance, please see that product's Help for instructions, or contact their technical support department. Clear the 'No Printer' check box in the form or report. 1. Open the form or report in Crystal Reports Designer. 2. Select File / Printer Setup. 3. Clear the 'No Printer' check box. 4. Save the form or report If the error still occurs, obtain a more specific error from within Crystal Reports. 1. In Sage MAS 90 or 200, open the form or report. 2. Click the 'Form' or 'Design' button to open the form or report in Crystal Reports Designer. 3. Click the 'Refresh' button. A more specific error should occur. 4. Search the Sage Software knowledge base for the specific error.

v5.2.3 std I search and oddly even though I reran WKSETUP there was no crpe32 on this server

64 Bit OS??

You can copy the crpe32 file from another computer, just make certain it is the right file for the OS.

yes 64 bit, I copied one to it, but still did not like it. Came up with another solution to finish payroll and will go back to server to see about fixing that when payroll is done. Thanks everyone!

Which folder were you looking for it in?

syswow64, but searched whole server and it was not there. Odd because I reran wksetup and crystal was already installed and II still could not find it.

It might be hidden. You may have to show hidden files, something like that.