Sage 100

 View Only

  • 1.  I recently upgraded a system from Sage 100 2014 St

    Posted 04-12-2016 12:09
    I recently upgraded a system from Sage 100 2014 Standard to Sage 100 2016 Standard and now when I try to launch the Sage Intelligence The system doesn't appear to respond. The program asks for a module date but after it is entered, the report manager or report viewer just don't show up. This is a parallel migration. Any ideas?


  • 2.  RE: I recently upgraded a system from Sage 100 2014 St

    Posted 04-12-2016 12:52
      |   view attached
    Are you running this from workstation? It installs as a part of workstation client install. I've attached the instructions I followed when I did this.

    Attachment(s)

    pdf
    Sage_100_2016_Customer_Upgrade_Guide.pdf   25 KB 1 version


  • 3.  RE: I recently upgraded a system from Sage 100 2014 St

    Posted 04-12-2016 13:04
    There's a known issue with that on at least one version. The only work around for now is to launch from outside Sage 100.


  • 4.  RE: I recently upgraded a system from Sage 100 2014 St

    Posted 04-12-2016 14:06
      |   view attached
    This is actually happening on my machine right now. I can see the Sage Icon flash in the task bar, but then just disappears. This happened to me once before and I followed the environmental requirements and found that VTSO was not installed properly. I haven't had time to troubleshoot on my machine, but maybe check all this stuff.


Related Content