Sage 100

 View Only

  • 1.  I am attempting to upgrade a client from Sage 10

    Posted 04-04-2018 13:56
    I am attempting to upgrade a client from Sage 100 Standard V4.05 to V2017 and when I am migrating the System I am receiving this error during the Post Merge Prepared failed with the following error: The D/M is invalid... And the Migration exits I found an article on the SAGE KB that the SY_Griddefinition.m4t might be corrupted and replaced it with clean 4.05 version. Still blowing up. Any suggestions?


  • 2.  RE: I am attempting to upgrade a client from Sage 10

    Posted 04-04-2018 14:21
    D/M as in Data Migrator? Is that module installed on the 4.05 side?


  • 3.  RE: I am attempting to upgrade a client from Sage 10

    Posted 04-04-2018 14:25
    I review the sy0ctl and NO D/M present. This customer has had MAS90 for ever!! No Data Migation for them...


  • 4.  RE: I am attempting to upgrade a client from Sage 10

    Posted 04-04-2018 14:27
      |   view attached
    Found it here you go

    Attachment(s)

    pdf
    dm_invalid.pdf   69 KB 1 version


  • 5.  RE: I am attempting to upgrade a client from Sage 10

    Posted 04-04-2018 14:29
    :( Tried that. it didn't work.


  • 6.  RE: I am attempting to upgrade a client from Sage 10

    Posted 04-04-2018 14:41
    darn...


  • 7.  RE: I am attempting to upgrade a client from Sage 10

    Posted 04-04-2018 14:44
    I just got a response from Ronnie.. I post the results..


  • 8.  RE: I am attempting to upgrade a client from Sage 10

    Posted 04-05-2018 04:48
    @JimWoodhead I hope you got this resolved with Ronnie. I had an issue recently involving a sy_griddefinition.m4t table. Tried everything to remove some udfs from the so detail panel. We could hide them but not completely remove them. Fortunately this was premium and we removed all traces of the udfs by DELETE from sy_griddefinition.m4t Where IOLVar = 'UDF_XXXX$' OR IOLVar = 'UDF_PARTNO$'. etc I wonder if you tried a test conversion after deleting any remnants of the screen customization from sy_griddefinition.m4t if that would resolve it.


Related Content